Windows 10: Hp in -firmware - 15.66.0.0 won’t install

Every sense my HP laptop updated to windows11 my computer has become a nightmare. Can someone help me

:)

 

Raid 0 help

Hi all, I've followed the IRST raid installation directions and I have created myself a Raid 0 volume. Rapid storage confirms my successful migration from a system disc to a raid 0 array. I'm also able to select it as my boot device in BIOS, but what I don't understand is why it is not listed in my Drives under my computer

In fact, my computer still lists my original C: drive with the original capacity. I feel as if I've miss an important step here and I'm unsure how to proceed.

 

speed of processor 1 in group 0 is being limited by system firmware !?

I am seeing several messages in the event log shortly after I boot (the adapter message appears earlier than the processor messages):

• A command sent to the adapter has timed out. The adapter did not respond.
• The speed of processor 0 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 1 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 2 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 3 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.

What could be causing this? My firmware is up-to-date.

 

Raid 0 help

You need to resize your NTFS partition. Run (Super + R; the run dialog box) and execute "diskmgmt.msc". You'll see that your RAID-0 is only partitioned to half of the array's size. Converting a disk to RAID doesn't do anything to the size of your partitions.