Windows 10: Hp laptop fix in Automatic repair process

Hp laptop fix in Automatic repair process Your pc did not start correctly

:)

 

HP Envy X2 Laptop Critical Process Died in Windows 10

Have a HP Envy X2 laptop with Windows 10. When I power it on it:

1. Goes into Preparing Automatic Repair state with the HP logo and spinning dots below it.
   
2. Then goes into the Blue screen of death stating Critical Process Died.
   
3. After about a couple of minutes the HP logo reappears with the spinning dots (but no automatic repair message)
   
4. Finally the laptop shuts down.
5. I attempt to power it on again, then it repeats the previous steps.

So I cannot get into Windows 10. I've tried getting into safe mode but was unsuccessful.

I have the Windows 10 media file on an USB drive. Can someone advise me how do I install a clean copy of Windows during the boot up process? Or at least get into safe mode?

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

Automatic Repair Loop

Hi Charlene,

Your concern regarding the device going into an Automatic Repair Loop can be caused by change on its settings/configuration or broken system files. To effectively assist you with your concern, can confirm if you've made any changes on your device prior to
your concern?

As an initial step to get back into the normal Windows screen, we suggest that you perform a
Startup repair. The repair will attempt to fix any broken components/files which may prevent your device from booting properly. To do this, follow the steps below:

• On theAutomatic Repair screen, select Advanced options.
• Select Troubleshoot.
• Select Advanced options.
• Select Startup Repair.

We'll appreciate if you can send us an update.