Windows 10: HP LaserJet Pro M12w reports fixed "Attention Required".

HP LaserJet Pro M12w reports fixed "Attention Required". This printer is installed on Windows 10 and is connected in Wi-Fi with the home network router. Report fixed "Attention required" and does not start printing. You can only print by running the troubleshooter, but in some cases not found it doesn't even start with that intervention. Perform all possible HP online support procedures that have not led to any useful results by failing to identify what causes the message to appear. I thought of a possible Windows cause since the troubleshooter almost always buzzes to start printing. Where can I look for the solution? Thank you.

:)

 

Printing problem with HP Color LaserJet Pro MFP M177fw

Hi,

Thank you for update and reply.

I suggest you to refer the HP link and perform troubleshooting steps suggested and check.

http://support.hp.com/us-en/product...-series/5303438/model/5303443/troubleshooting

If issue still persists I suggest you to contact HP support.

http://support.hp.com/us-en

Hope this information helps. Kindly post back with the updated issue details for further assistance.

Thanks

 

Printer requires attention...

I installed Windows 10 on my HP PavilionX2 about a week ago and after a bunch of false starts finally got it going. I set up my HP Laserjet Pro 1102w printer with HP's installation application and got new drivers, etc. The installation was successful.
When I attempted to print. I got the message that my printer requires attention. I use generic cartridges, which seems to contribute to the problem. However, I discovered that the printer
would eventually print whatever I sent to it several hours later. So, whenever I want to print I just ignore the message about requiring attention, but I have to wait several hours before Windows 10 will finally release the document for printing.
I had no problem whatsoever in Windows 8.1. This is new with Windows 10. Is there any way to fix this?

 

HP Laserjet Pro CM1415fnw color MFP can no longer scan

Hi Matt,

We appreciate you for being a part of Windows 10.

Before proceeding, we need more information to help you better.

• 
  Have you made any changes to the firewall settings prior to the issue?
  
• 
  Did you try to restart the HP LaserJet Pro CM1415fnw color MFP and check if you are able to fix the issue?
  

Until you get back to us with the required information, you may follow the suggestions provided under the Windows section in the below article and check if it helps.

http://support.hp.com/us-en/document/c00040499/

Kindly let us know if you need any further assistance with the issue. We are glad to assist you.

Thank you.