Windows 10: I accidentally wipes out my whole pc with that clean disk cmd

So basically I was trying to convert my dynamic partition into basic partition but ytbers suggested me to do diskpart and after that sel dis 0 after that clean and from this it started deleting stuff and now idk how to put windows in my pc again and don't even know what to do and how to recover my data

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Disk management

Thanks. There was a recovery partition I could not get rid of. MS help did this so I could get Disk 3 wiped & to a single partition:

Steps that solved the issue:

-

open cmd with admin rights

typed:

dispart

list disk

select disk 3

clean

create partition primary

select partition 1

assign

 

Windows 10 recovery doesnt wipe my hard-disk

Hi, to clean install Windows you need to create a bootable flash drive or other medium from which to boot your PC. That's covered at Step 1 of the tutorial shown below (Clean Install..)

Windows 10 Tutorial Index
- searchable list of tutorials - search that page for
clean install
and you will see this as 2nd link found
Clean Install Windows 10

At step 13/14 you have the option presented to you where you can delete existing partitions.

Note: some suggest- as you have a desktop- physically disconnecting other drives just to ensure Windows is installed exclusively on the one drive.