Windows 10: I an Azus S433EA-AM214TS CN:3WF7 Serial: LAN0CX03L79442E bought from Thinking Tools Inc -...

I an Azus S433EA-AM214TS CN:3WF7 Serial: LAN0CX03L79442E bought from Thinking Tools Inc - Cebu, Philippines with Sales Invoice No: 284269. It is currently Bitlocked

:)

 

Windows 10 serial on OEM


So I'll summarize steps made...

1. Saved serial number (taken with Belarc Advisory) from preinstalled (half chinese language) Windows 8.1 (don't know exactly the version, suspect Windows 8.1 with bing) on tablet
2. Formatted tablet
3. Tried to make a clean Windows 10 (HOME, HOME N and also PRO, everytime with the same result) install with ISO taken with MediaCreationTool, during install (and also after completing installation) it says that the saved serial is not valid
4. Tried to reinstall Windows 8.1 (ISO taken with MediaCreationTool again) HOME, it says that the serial is not valid

So i suspect that the saved serial, is from a WINDOWS 8.1 WITH BING OEM version and this kind of ISO is not accessible/downloadable anywhere (at least I can't find it, any suggestion?)

Still not tried SHOWKEY with that serial, I am in office now, and the serial is saved on a usb pen at home, will try this evening.

So I'm stucked but if everything is like I suspect, it's incredible. If I have a tablet/notebook/netbook with Windows 8 preinstalled, it seems that I can update to Windows 10 without problems, but if I want to make a clean Windows 10 install that serial is not valid...

 

azus startup problem

i have an azus laptop with a startup problem upon pressing power button short azus screen then says reboot and select boot device or insert boot media in selected boot device an;d press a key. what does that mean

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".