Windows 10: I can not delete files even though I am the Administrator!!

I have a relatively new HP laptop with Windows 11 64 bit and I cannot turn on Memory Integrity because of several Logitech .sys files. When I try to delete those files per Microsoft instructions, I get a message saying that I must have Administrator Permission, but I AM the administrator! How can I make it, so I don’t get that crazy message?

:)

 

App for deleting files while being used by another process...

Most of the time, booting in safe mode, as administrator, will enable you to remove those files (maps).

however, there are some programs out there to do just whatyou ask, I once found one after some searching on google. So either try my suggestion, or in fact search on google perhaps?

"Force delete" will bring up enough info on this.

 

Unable to delete a file

Hi Brent,

There are a lot of possible reason why the issue occurs, we suggest that you access
safe mode
and
delete the files there. If the same issue occur,
reboot
your PC and run these following
methods of troubleshooting
steps:

Method 1:
Run SFC Scan.  

To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Method 2:
Run DISM Tool.  

To run
DISM Tool, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    

NOTE:
This might take a while to finish scanning.
Do not cancel. 

Method 3: Clean Boot.

To perform a
Clean Boot, click
here.

Note:
Reset the computer back to
Normal Mode
once you are done with the troubleshooting by following the section
"How to reset the computer to start normally after clean boot troubleshooting"
from the same article.

Let us know how it goes.

Regards.

 

Deleting Hiberfil & Pagefile

You would have to move your Page File to a different drive to get rid of that file, however you can make is smaller by adjusting the size in Windows.

To get rid of Hyberfile.sys you need to disable hibernation by doing the following:

• Click Start, and then type cmd in the Start Search box.
• In the search results list, right-click Command Prompt, and then click Run as Administrator.
• When you are prompted by User Account Control, click Continue.
• At the command prompt, type powercfg.exe /hibernate off, and then press ENTER.
• Type exit and then press ENTER to close the Command Prompt window

Then you can delete the hyberfile.sys file.