Windows 10: I cannot run any of the dism commands. System just randomly shuts down Event Log is full of...

As i said in title none of the "DISM" commands wont work neither in power shell or cmd with administrator access. I can send you my cbs.log if that's what's needed to resolve the issue. Event ID some of the errors: 10016; 23; 7; 1030; 123; 131; 200; 201; 202... and so on.Please HELP ME i have a lot stuff on my pc that i cannot lose. Reply

:)

 

Event "Error" Log Repair required (Windows 10)

Hi,





There are a lot of
possibilities why these errors occur in
your event logs. The errors depends on what it is related to. It could be your
application, drivers, firmware, hardware, or your storage devices. You can check this
link for further information regarding event log issues.



We suggest that you perform these following methods of troubleshooting steps and check if there's any changes:



Method 1: Update your drivers.

To know how to update your drivers, click
here.



Method 2:
Run SFC Scan.  

To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Method 3:
Run DISM Tool.  

To run
DISM Tool, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    
  
  
  

NOTE:
This might take a while to finish scanning.
Do not cancel. 



Method 4: Clean Boot.

To perform a
Clean Boot, click
here.



Note:
Reset the computer back to
Normal Mode
once you are done with the troubleshooting by following the section
"How to reset the computer to start normally after clean boot troubleshooting"
from the same article.



Let us know how it goes.



Regards.

 

APPcrash event Logs

Hi Dennis,

Thank you for keeping us updated.

This issue may happen due to system file corruption. I suggest you to run System file checker. System File checker (SFC) scan is done to check if there are any corrupted system files that could be causing this issue. Kindly follow
the below given steps:

• Press Windows key + X, select
  Command prompt (Admin) to bring up elevated Command prompt.
• In Command prompt type sfc/scannow and press enter.
• Restart the computer.

If no corrupted system files were found in the previous state, then I suggest you to try the following steps:

• Open command prompt by pressing Windows key + X and selecting “Command prompt admin”.
• In command prompt, type the following commands and press Enter after each command:

DISM.exe /Online /Cleanup-image /Scanhealth

DISM.exe /Online /Cleanup-image /Restorehealth

• Close the command prompt and restart the PC and check if it works.

Please post back with the information asked and the results, we will be glad to assist you further.

 

HP Notebook shuts down randomly

Hi David,

It is possible that your Notebook shut downs randomly due to corruptions. To isolate your issue, we'd like to gather more information:

• Have you made any recent changes prior to this issue?
• Did you get any error messages?
• Are you referring to Internet Explorer or Microsoft Edge?
• What troubleshooting steps have you done so far?

Meanwhile, we suggest that you follow that steps in this
article to scan for corruptions and restore corrupted system files. If the issue still persists, we recommend that you perform the instructions to restore Windows corruptions error by clicking on this

link.

Keep us posted if you need further assistance.