Windows 10: I cant access "Reset This PC" option.

Just as the title says, whenever i search it in using windows key, all it does is redirect me into this.

https://imgur.com/a/bUj7Ejm

submitted by /u/Celized
[link] [comments]

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

No "Reset This PC" option

Hi,



Thank you for writing to Microsoft Community Forums.



For better clarity, it would be great if you can help us with the details requested below:

• Where exactly are you looking for the Reset this PC option?
  
• Were you able to successfully clone the drive?
  
• Could you please provide more clarity on, “On original hard disk the WinRE recovery partition was last partition. On new hard disk that partition had moved to first position”?
  
• Were you able to get the Reset this PC option by following the steps mentioned in the article provided by you?
  

If you wish to reset the PC, there are multiple ways to do it. You may want to refer the steps mentioned in the article

Reset or reinstall Windows 10.



However, please reply with the details requested above to help you with the appropriate details.



Regards,

Nikhar Khare

Microsoft Community - Moderator

 

I cant access to my wifi router

It should be listed under "Advanced". There will be a table and there should be a checkbox next to it.