Windows 10: I can’t connect to WiFi. Tried everything, then I figured out I have a problem with WLAN...

When I try to run it, error 1068 shows up. I really need help, thanks

:)

 

UNWANTED auto-connection to WLAN

Dear farby,



Thank you for your suggestions, and apologies for my delay in replying. Poor health.

I have tried each of the suggested solutions, but still do not have the wanted result.

• WLAN connection deleted and reconfigured. While the WLAN was absent, the provider internet connection began self-connection just as the WLAN had done.
  • On reconfiguring the WLAN, both it and the provider internet connection began self-connecting.
• On re-setting the factory settings, as soon as boot completed, internet connection was requested. On dismissal of request, WLAN self-connected as before.

It would seem that something really wants to get out onto the web, or maybe the 'phone is just 'phoning home.

Please help.

 

Problems when sharing WiFi with the Virtual Adapter

For many years I have always shared Internet to my devices like phone and tablet with my PC's WiFi antenna through the Microsoft Wi-Fi Direct Virtual Adapter, I only use it for that, since I have a cable connection, and I start the wifi with the command NETSH WLAN start hostednetwork previously having done the settings of NETSH WLAN set hostednetwork mode=allow ssid="Wifi" key="password".

For my devices to connect it is necessary that the Virtual Adapter that is created with that command has access to the Internet, for this I have to share the Internet from my Ethernet adapter to the Virtual Wifi adapter.

For some time now (a couple of months) I've been experiencing problems when sharing the Internet through that medium. The problem is that when I start the WiFi my devices do not connect, they say "Getting IP address" and never connect.

I have found the solution and I have to do the following:

1. Disable the Virtual Adapter with the command netsh wlan stop hostednetwork.
2. Remove the connection sharing from the Ethernet Adapter.
3. Activate the Virtual Adapter with the command netsh wlan start hostednetwork.
4. Adding connection sharing from the Ethernet Adapter to the Virtual Adapter again.

By doing these steps my devices can now be connected to the Wifi, but sometimes it doesn't work if I do these steps too quickly. I have noticed that if I do step 3 and 4 too quickly it does not work and I have to repeat the process but doing these last two steps more slowly, until the Virtual Adapter gets an IP address 192.168.137.1 from Internet Protocol version 4

Also this problem does not occur 100% of the time. Sometimes when I run the command to start the Wifi everything happens fine and my devices connect well but this only works after my PC has been on for at least 5 minutes (I haven't counted it). If I run the command as soon as my PC has turned on then it doesn't work anymore.

As I mentioned before this problem didn't occur before because I had configured a .bat file that ran as soon as the PC was turned on with the NETSH WLAN start hostednetwork command and everything worked fine.

Now, I would like to go back to before when everything was fine so that when my PC starts up the WiFi too and I don't have to do all this protocol all the time, but with a simple command everything is solved.

Could someone give me a hand with this?

 

Can`t connect with WLAN C3-00

hi! to connect with wlan using your C3-00, here are the steps that you can try...

menu > settings > connectivity > wlan...

select search wlans, phone will select for any wlans in range.

choose the network that you want to use from the list, select connect.

it basically asks for the wep key.



save wlan for future use > yes

press options > save



hope this will help you sort it out!