Windows 10: I can’t log on to my computer and i can’t open command prompt

I have disabled services in msconfig and can’t log on to computer. I can’t figure out how to open command prompt as i have been told to do. I open up the troubleshoot menu in recovery environment but there is no option for command prompt or reset. The only options showing are Start Up Settings and UEFI Firmware Settings. Help?

:)

 

command prompt will not open in safe mode with command prompt

I am repairing a laptop for a friend and I need to access windows in safe mode and the owner has forgotten the password to the main user. I tried logging on with the administrator profile in safe mode but it is not showing up so I was going to use command prompt in safe mode with command prompt but command prompt will not open when I boot that option. Does anyone have any hints for me to figure this out?

 

command prompt will not open in safe mode with command prompt

Would I just follow the same steps within safe mode after hooking up to the other system?

 

How does Windows boot to advanced recovery option e.g. command prompt?

- that gives me a 454 'Unexpected error' This tells me that the BCD is partially corrupted.

The commands: shutdown.exe /r /o /f /t 00
or: %SystemRoot%\System32\Cmd.exe /c reagentc /boottore&shutdown /r /f /t 00
should boot into Recovery if everything is configured correctly.
FYI, If Windows is configured correctly:

1. If Reagentc is disabled, you still can get into Recovery but with limited options.
2. If Reagentc is enabled, you'll get all options.
3. If you boot Windows using Recovery USB stick, You'll get into Recovery with couple of options missing.

Here's my suggestion if you want to try:
OPTION 1: Will save the trouble of re-install Windows.

1. Download the image of my first 3 partitions (450MB Recovery, 100 MB EFI partition, and 16MB unformatted primary)
   EFI_Boot-00-00.7z - Google Drive
2. Run Macrium and restore the image from step 1, overwriting your existing 1st three partitions, leaving C alone.
3. Delete the 490MB Recovery partition.
4. From Macrium, run fix boot problems.
5. Reboot. Open Admin command prompt then run Reagentc /info to make sure that it is enabled. If not, enable it.
   if failed to enable, reboot and try again.

OPTION 2: Assuming you've already had Windows backup with Macrium.

1. Wipe out the first 5 parttiions. (450MB, 100MB, 16MB, C Drive, 480MB)
2. Fresh install Windows 10
3. Restore C drive from backup image, run fix boot problems
4. repeat step 5 from OPTION 1 above.