Windows 10: I factory reset my pc and now it’s not letting me sign in popping up with a message saying...

I factory reset my pc because it was being slow. After it was done I went to sign in and it wouldn’t let me it kept asking for password which I used pin. It wouldn’t let me use pin and I’ve tried so many thing. I got the password and when I finally entered it it said The User Profile Service failed the sign in User profile cannot be loaded. I tried going into command prompt but it wouldn’t open cause it wanted me to have an administrator account after I turned on safe mode and logged in it just put up a black screen and didn’t do anything.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

factory reset

Hi,

There shouldn't be an issue singing in to your computer after performing a factory reset. What's odd is that the error message "Your account has been disabled" is showing up. However, we suggest that you provide us a screenshot of the signing
in page with the said error message. It's for us to determine what would be the steps that we need to isolate your concern.

We're looking forward to your response.

 

Factory reset "Error" message

Hi Jaxyn,

It seems that the issue that you initially encountered also interferes with the factory reset. In order for us to provide the appropriate solution, we'd like to ask for additional information. Please answer the following:

• Aside from failing at 30%-32%, are you also getting an error message or code?
• What troubleshooting steps have you tried so far?
• What build and version of Windows 10 are you using?

We hope to hear from you soon.