Windows 10: I got a error during factory resetting my pc and it put me in recovery mode

i factory reset my pc and it gave me an error mid way through it then i’m no stuck on two black screens and i can’t turn my pc off unless i unplug it by the wall

:)

 

factory reset will wipe the data in PC?

Hello,

I realize that you are trying to perform a factory reset to the computer. We will help you.

• How are you trying to perform a factory reset in your computer?
• What issue are you facing to perform a factory reset?

I suggest you to perform a recovery with keep my files in Windows 10.

Recovery options in Windows 10.

Keep my files

What it does

• 
  Reinstalls Windows 10 and keeps your personal files.
  
• 
  Removes apps and drivers you installed.
  
• 
  Removes changes you made to settings.
  
• 
  Removes any apps your PC manufacturer installed. (If your PC came with Windows 10, apps from your PC manufacturer will be reinstalled.)
  

Refer:
Recovery options in Windows 10

To Reset you’re PC,

* On your login screen, hold Shift button,
then right click on Power button and select
Restart

* Select Troubleshoot> Reset this PC > Keep my files.

Kindly let us know if you need any further assistance with Windows. We are glad to assist you.

 

Problem resetting PC - no recovery image registered

Yes, need to clarify .... "reset" is a generic meaningless term.
- Windows recovery ?
- proprietary device recovery (factory default setting) ? (Absolutely NOT recommended if this was the case)
- and/or Windows repair (often confused/interchanged with "recovery" ?

How was this attempted (steps taken) ?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".