Windows 10: i got this problem after doing Reset this computer i tried everything

that is the problem

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Problem Networkin Two Computers

Hi Jack,

Thank you for replying.

• 
  Have you tried the steps provided by me?
  
• 
  If yes, what are the results?
  

If no, I would suggest you to follow the steps and reply us back with the status of this issue.

 

How do I reformat entire computer?

Thanks Rich and dalchina. I'll concentrate on that option.

Will that also convert my disk from dynamic back to basic, or do I need to do that as a separate step prior to installing Windows?

ADDED LATER:

1. Booted from USB
2. did not get the screen shown in the tutorial
3. Options from USB Boot = Choose an option -> troubleshoot -> reset this PC -> remove everything-> all drives-> fully clean the drive -> There was a problem resetting your PC