Windows 10: I had to reset my computer. Before the reset, I didn't need a PIN to open Windows 10. Now...

I had to reset my computer. Before the reset, I didn't need a PIN to open Windows 10. Now I need a PIN to open Windows. How do I eliminate the need for a PIN to open Windows?

:)

 

How to reset Windwos 8 Password?

http://windows.microsoft.com/en-us/windows/what-do-forget-windows-password#1TC=windows-8

• If you've forgotten your Windows password, there are several ways to retrieve or reset it:
  • If your PC is on a domain, your system administrator must reset your password.
  • If you're using a Microsoft account, you can reset your password online. ...
  • If you're using a local account, use your password hint as a reminder.

 

Resetting Bios Password

I am doing some spring cleaning, getting rid of old desktops, laptops, and routers. Regarding the computers, I am wanting to wipe the hard drives with Darik's Boot and Nuke software. When I booted up one old Dell desktop from 2001, I learned that it requires a BIOS password. Why I ever put one on is beyond me. Unfortunately, I have forgotten the password. The rest of this message will be about wanting to know if my understanding for resetting the BIOS password is correct.

Technically, this thread/message isn't about Windows 10 specifically. But it does relate to hardware, and I am hoping that it would apply to a significant number of computers, so I hope this message is okay.

I called Dell, and the technician said that I needed to reset the jumper on motherboard to reset the BIOS password. After opening the case on my old Dell computer and hunting on the internet, this is the what I think I have learned. I will present photograph of a portion of the motherboard.





I have put a red rectangular box around what I think is the jumper for the BIOS. I note that "PASS" is written on the motherboard beside those three pins.

I believe these are steps I need to follow. Please correct me if I am wrong.

1. Turn off and unplug the computer. (It has been off and unplugged for about ten plus years. I just plugged it in today. I am not sure if this information is relevant. Perhaps it helps with regard to the motherboard's battery.)
2. Open the case and locate those "PASS" pins again.
3. Switch the jumper from the current two pins to include the third pin and middle pin. Leave it there for 5 seconds or more. In other words, move the jumper over one pin for a few seconds.
4. Reset the jumper back to its original position with the original pins.
5. Plug in the computer, and attempt to boot it up.
6. Assuming it boots up, open CD tray and put in Darik's Boot and Nuke software and follow the steps.

Is there any information that I am missing? Do I have the correct location for the jumper? Are my steps correct?

Thank you for your help.

 

How to reset whole netsh? (Windows 7)

Was wondering has the commands changed somehow since on Windows XP and on Windows Vista 'NETSH INT RESET ALL' cleaned entire netsh up from top to bottom.

Now on Windows 7 this same command says no go and only way I can see it is by building .cmd/.bat which does something like:

Code: netsh winsock reset all netsh int 6to4 reset all netsh int ipv4 reset all netsh int ipv6 reset all netsh int httpstunnel reset all netsh int isatap reset all netsh int portproxy reset all netsh int tcp reset all netsh int teredo reset all[/quote] now the king of the hill of bugs is this doesn't actually do even it's job even after reboot. values setup to are not reset to defaults. (I know I could add more entire list of entries there is, but looking for clean delete/wipe settings & default everything not to dump entire list of resets.)

So, anyone got a plan B?