Windows 10: I have 3 network drives.....Win11 can only write to one of them...other two are...

Have mapped 3 nework drives...side by side.Added 1st drive Z: .....an nvme type.....and Bingo.....can read/write/edit files insideThen....Added drives 2 and 3 Y: and X: .....and both are write protected.Right clicking to properties, suggests that all 3 drives have same permissions.All drives similarly formatted to NTFS.Used same credentials when mapping the drives....why are they behaving differently please???

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Cannot access shared network drive

I could scream! so much time wasted on this stupid error, as if time is not precious enough!
It probably would work fine if I could see the other computer! But I cannot see the other computer!

 

Cannot access shared network drive


Personally, I wouldnt use Everyone. If anyone hacks into you, they have full access to everything and can demolish everything on your raid. I would rather set up accounts and access separately for each person. That way, I know who did all that damage. In the end with a little extra work, I feel more secure by using Authenticated Users.


If this helps.
step 1 create non-microsoft account and without email and address without admin rights
step 2 share a drive or folder to specific user account (if Everyone is listed, remove it)
step 3 set security > add Authenticated Users (if more than 1 account) or add specific users
step 3a remove Everyone from list
step 3b uncheck full control and write for all items listed except SYSTEM and Admin account.
step 4 right click Start > Computer Management > System Tools > Shared Folders > Shares ... to verify settings and change anything else. You can also see the number of connections to each share here.