Windows 10: I have a blue screen but i can´t detect the error in the minidump file

Can you help me detecting the error in these minidump files, I already run the HP Diagnostic tool and no error was detected, I run the full diagnostic and no error was detected but the computer still show blue screen one a week. https://drive.google.com/drive/folders/1W6hQe1dPZ_OFlK3WoIZLU0nxUfHYo99N?usp=sharingSO: W11Version: 24H2 SO 26100.3194HP ProBook 640 G8 Notebook PCTermal paste already changedOriginal AC AdaptarOriginal Storage and RAM installed no changes

:)

 

Error. Blue Screen

Hi,

In addition to the above mentioned solutions by Community members, I would like to add the following:

Before we proceed I would like you to answer the following question:

• 
  What is the make and model of your computer?
  
• 
  Did you make any changes prior to the issue?
  

The issue might occur due to Viruses, or something changing/deleting in Registry Files, a failure during Bootup, or a corrupt file which could be due to age of a computer or viruses or somebody tampering with files.

I suggest you to follow the step below:

Step

I suggest you to refer the article below and check if it helps:

Troubleshoot blue screen errors

Resolving Blue Screen errors in Windows - Microsoft Support

Please get back to us with updated status, we will be happy to assist you.

 

Blue screen error - SYSTEM_SERVICE_EXCEPTION

Hi,

Blue screen errors usually occur due to system file corruption and outdated drivers. For us to provide an effective solution, we would need you to answer the following questions:

• Which build of Windows 10 is currently installed on your computer?
• What changes have you made to the device before you encountered these errors?

In the meantime, we suggest performing the steps available in this link. It serves as a guide on how
to troubleshoot blue screen errors in Windows 10.

We're looking forward to your response.

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.