Windows 10: I have a Dell latitude with Windows 10 pro it will not allow me to do a complete factory...

I have a Dell latitude with Windows 10 pro I think I have a corrupt copy of windows I cannot do any type of reset a full factory reset or even a partial one and keep my files I go through every way to start the reset process when I hit reset I get a message back that says your device could not be reset none of your information has been changed

:)

 

how do i do a factory reset on my dell latitude with windows 10 pro

how do i do a factory reset on my dell latitude with windows 10 pro

 

Dell Latitude E4310, missing driver, Windows 10

Hello,

I started with a fully functional Dell Latitude E4310 (circa 2011) with Windows 7 pro. Microsoft get windows 10 app came up all green for upgrading to Windows 10. Upgraded, and the laptop became very slow. It's basically become unusable. Before you ask -
it has 8Gb RAM.

Investigation (too little too late):

I'm missing one driver after upgrading.

Device type: Other devices

Manufacturer: Unknown

Location: on PCI Express Root Complex

No idea what this device might be or if it's related to my performance issues. Should have made a list before upgrading.

Now (again, too little too late), I check Dell's website - for drivers. They have no plans to support Latitude E4310 with Windows 10.

So. Other than _running_ back to Windows 7 as fast as I can, does anyone have any suggestions?

 

No drive found on my internal hard disk on Dell Latitude E5430.

Hello,My laptop (Dell Latitude E5430) was working perfectly till yesterday. But yesterday night, it restarted on its own and ever since, it's stuck at this screen:



Also, inside the BIOS, no UEFI bootable hard disk drive is being listed.



The UEFI flash disk option shown above is that of my bootable pen drive with Windows 10 installation copy.I googled this issue a bit and the results were as follows:

1. one thread suggested that I should run Dell's internal diagnostics to see if there anything wrong with hard disk. I did that but every component, including the hard disk one, passed these internal test.
   
   
2. a second thread suggested that I should try to remove and reseat the hard disk. I did that following Dell's user manual.
3. another thread suggested that I should reinstall my windows 10 afresh. But when I try to do so, the windows installation wizard doesn't list any drive in the hard disk. It's as if it doesn't detect hard disk at all.
   
   

In a nutshell, while the hard disk is being detected, but none of its drives is. However, the hard disk consisted of 3 drives:

1. C: with the windows' and applications' installations,
2. D: with all of my data,
3. E: which was recovery drive.

Any troubleshooting suggestions?I'm sorry I am not able to help you guys with any logs and stuff because I don't know how to get them when I can't get my Windows to boot. I'm not even sure if this is the correct section where I should be posting this thread.. I'm just so confused right now. *cry

A few weeks ago, I had upgraded (not fresh installation) from windows 10 version 1607 to 20H2. The version 1607 installation was a clean one (from scratch, after formatting the hard disk and creating new partitions).