Windows 10: I have a right to access which ever website I please so delete and remove Cisco Umbrella ASAP

Remove cisco umbrella immediately because as an adult, I purchased this laptop and not you and therefore, I have the right to access whatever website I desire. You nor any network administrator will dictate what website I have such a desire to access because if you do, it simply says just how blatantly ignorant you are. So delete cisco umbrella immediately!

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Cisco Aironet Access Points Unauthorized Access Vulnerability

Source: https://tools.cisco.com/security/cen...-unauth-access

 

Cisco AnyConnect

Hello
Xiu RuLim,

It seems that there are some traces in the registry left even after uninstalling the program.
I suggest that you follow these steps to delete the registry keys related to Cisco AnyConnect.

Disclaimer: The steps below includes system registry modification. However, serious problems might occur if you modify the registry incorrectly. Therefore, make sure that you follow these steps carefully. For added protection,
back up the registry before you modify it. Then, you can restore the registry if a problem occurs.

Make sure to backup registry first, please refer to this support article:
How to back up the registry in Windows. Please follow the steps below:

1. Press Windows key + R. The run dialog box will open.
2. Type regedit, then press Enter.
3. Browse to the following location: HKEY_CLASSES_ROOT\Installer\Products\
4. Within the Products folder, locate and delete the registry key which contains product information for
   Cisco AnyConnect Secure Mobility Client.
   
   ◦Each registry key within Products is an alphanumeric string. Select the first key and look on the right side for ProductName REG_SZ Cisco AnyConnect Secure Mobility Client. Go through each key in the Products folder until you find the one for Cisco AnyConnect
   Secure Mobility Client.
5. Close the registry editor.
6. Once done, try to start the installation for Cisco AnyConnect.

Hope this helps. If you would like me to provide additional advice, simply respond to this thread. I will get notified and I’ll reply to you as soon as I can.