Windows 10: I have another question on this topic. That is, my disk was not formatted?, all the files...

Dear Эрнст,Thanks for your quick reply, the answer is yes. The partition format you described can exist on a disk with Windows installed. FAT32 and NTFS are file system formats supported by Windows systems, and their respective uses are also in line with system design requirements. Therefore, this format is possible and is a normal configuration.I hope the above information is helpful to you.Best WishesPyke.D Microsoft Community Support Specialist

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Windows format disk message

Hello Marcos,

There may be several reasons why you are being prompted to have your pen drive formatted every time you plug it in to your PC. This prompt, however, may not be disabled. To isolate what's causing this issue, kindly answer the following questions:

• When did this issue start?
• Were there any hardware/software changes on your PC prior to this happening?
• Was your pen drive improperly pulled out from the USB port?
• Have you tried plugging your pen drive to a different USB port or a different computer?

In the meantime we suggest you to check if your pen drive appears under
Disk Management without any error. To check, follow the steps below:

• Click Windows + X.
• Select Disk Management.
• Check and see if your pen drive shows on the list.

We will be waiting for your response.

 

Cannot read files on floppy disk

Hi, I have files that I know are good on a floppydisk. On trying to access them a message says the disk need formatting. I have tried to use PhotoRec from the UBCD but it will apparantly only read HDD or CD/DVD.

Can anyone suggest a freeware program that might work. Thank you for your help.