Windows 10: I have been facing this problem where my pc goes into repair mode but after i get the blue...

submitted by /u/Vaucha
[link] [comments]

:)

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??

 

Blue scren problem

Hi Mary,



Thank you for bringing up your query on Microsoft Community.

Apologize for the difficulties that you're experiencing in Windows 10.

Not to worry, we’re here to help you out.

• 
  What is the exact\complete error message you get?
  

A blue screen error (also called a stop error) can occur if a problem causes your PC to shut down or restart unexpectedly.



As we are analyzing the dump files, let us try the following steps as a workaround and check if it makes any difference.

Step 1: Initially, I suggest you to start your computer in safe mode with Networking and check if the issue appears there as well. If it does not appear in safe mode with Networking place the computer in clean
boot state to identify the culprit program running in the background creating this error.



Safe Mode is a diagnostic mode that starts your computer in a limited state. Only the basic files and drivers necessary to run Windows are started.



Refer the article below:

Start your PC in safe mode in Windows 10

http://windows.microsoft.com/en-in/windows-10/start-your-pc-in-safe-mode



Step 2: Let us follow the steps suggested in the following article and check if ti helps in resolving the issue.

Troubleshoot blue screen errors

http://windows.microsoft.com/en-us/windows-10/troubleshoot-blue-screen-errors



Hope it helps.



Let us know the status, we are glad to assist you further.

 

Preparing automatic repair, then it goes black

In that case, you'll need to download the ISO file from another PC. Once the download is complete, follow these steps:

• Insert the installation media you created.
  
• Open your PC, select 5 or F5 to open
  Safe Mode with Networking.
• Then follow the steps on the
  Wiki Article by Andre Da Costa.

Keep us posted.

•