Windows 10: I have been getting a variety of bsod and I can no longer get to the desktop screen it’s an...

All the stop codes I’m getting :IRQL NOT LESS OR EQUAL:SYSTEM THREAD EXEPTION NOT HANDLEDRIVER IRQL NOT LESS OR EQUALAGE FAULT IN NON PAGE AREAAnd I have just gotten right now after 2 restarts were KERNEL SECURITY CHECK FAILUREATTEMPT TO WRITE TO READONLY MEMORYI CANT FIGURE THIS OUT NOR TURN ON MY PC IT JUST TURNS ON AND BASICALLY INSTANT BLUE SCREEN

:)

 

windows update stuck at installation screen and cannot get to desktop

Hi Sue,

To understand the issue better, I would like to ask some questions:

• Is the computer stuck in the Installing updates screen?
• For how long is the computer stuck in the screen?
• When was the computer last updated?
• Is the screen showing any percentage of installation?

Sometimes the installation might take a long time to install if the update is of large size. So, I suggest you to wait for sometime and check if the system boots to the desktop. If it is taking a longer time, then perform a Power Drain by following the steps
provided below:

• Shut down the Computer.
• Remove all power source (including battery if it is a laptop).
• Press and hold the power button for 15-20 seconds.
• Connect the power source and start the computer.
• After the computer boots to the desktop, suggest you to install all the pending updates.

Hope this helps. Keep us posted on the status for further assistance.

Thank you.

 

Cheap Photo box that will get the job done

WEll i took on this project for PP hes a hardware reviewer and wants to get the professional looking pics for the Pc parts

Materials:

• Big cardboard box

• a razor

• white material 3 yards

• cone lights

• stapler

• medical tape

• pvc pipe about 6 inches longer than your box

• white paint any cheap finger paint would work

the project I'm guessing will cost me $30 if it works out properly
I will post pictures and step by step as i do it

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.