Windows 10: I have iball wq77 tablet pc touchscreen is inverted please help me

I'm using iball wq77 tablet whenever i touches screen it works inverted like if i touch horizontally it works vertically

:)

 

Touchscreen's X axis is inverted on my tablet

Touchscreen's X axis is inverted.
If I touch right bottom corner, tablet thinks I clicked windows button in left bottom corner.

This happened after installing driver from the internet (before it was unknown device)

Device is now "Goodix Touch HID"
I found this driver by searching VEN_GDIX&DEV_1001 (device ID or something, I have Windows in another language)

 

Invert touchscreen

Is there any way so I can get the touchscreen inverted on the Y-axis through the registry?

If I click on the top of the screen with the pen, the mouse shows on the bottom, so the Y-axis is inverted, but X-axis is fine. I tried multiple drivers for the touchscreen, because the vendor doesn't respond to my e-mails so i can't have the correct driver.

There is any way so I can change any values on the registry so i can reverse the Y-axis? I have the problem touching the screen with the pen and also with the finger.

Thank you!

 

iBall Slide i701 Touchscreen not working after update to windows 10. Please Advice

I had this same problem with my resent purchased iBall i701 windows tablet, after upgrading windows 10 my iBall i701 touch not working properly. Then I visit iBall Service Centre in my place they also not fixed the issue and due to I had new product they
provide me DOA certificate to replacement the product from vendor. My vendor replace my iBall i701 windows tablet.

After receiving new iBall i701 I update the windows 10, then I received again the same touch problem. Then I try some few steps before going to visit iBall service center.

1. Check all device status in device manager (Working or No Working)

2. Found all device driver status ok.

3. Then Start > Windows system > Control Panel > Tablet PC Setting > Reset Calibration Data ( Reset if Button is highlighted)

4. Start calibration > Calibrate >Save

5. After all above doing my touch start working with new calibration data.

Hope this can help you. Sorry for grammar mistake.

Thanks