Windows 10: I have more than 3 million errors in S.M.A.R.T. parameter "RAW read error rate"

Hi everyone,in my desktop with i5 cpu, 8 Gb RAM and Windows 10 x 64, I have a 120 Gb Kingston SSD as a 120 Gb system. This disk has always worked perfectly and the used space is about 25 Gb I store my data in another disk.By running the information on the Crystal disk, I discovered an abnormal amount of errors in the Raw read error rate and other parameters, as you can see in the screenshot below.After several minutes of powering on, the amount of errors can increase to sometimes double.I don't know if this is all normal.My PC has never had a BSOD, it has never crashed, and I have never seen

:)

 

RAW Read Errors, help!

This post did not exactly give the answer needed.
It will more than likely keep the same SMART data, even though you format it (low level or what); unless, you have some app that will wipe the SMART data.
When you tested it in the other system, did the Raw Read Errors, Pending Sector Count or any other errors increase?

If the error counts still increase in the other system, then , definitely RMA it.
It is, probably, partly bad luck and partly... sloppy quality control, in that case.
If you do RMA that drive again, ask them to test the replacement before sending it.

However, if, the drive does not garner more errors, then you may need to looks else where for a problem.

EDIT:
Just a couple of questions. Have you done a test on your other drive in the first system (not the miniITX)? Is it showing any errors?

 

RAW Read Errors, help!

And how do you know this?

 

RAW Read Errors, help!

If it is controller problem then it should show Write Error Rate Warning and Seek Error Rate Waning as well.

I am not getting I/O error in Windows event logs, so it should not be the motherboard end. Must be cluster of weak sectors on the replacement HDD.