Windows 10: I just started to get stop code error and my computer just shuts down and restarts

This just started happening. Unfortunately, by the time I begin to read the message, it is gone.Is there anywhere that this would be logged, how do I find it and more importantly what do I need to do to fix this?I updated to windows 22H2 on December 31, 2022, I updated my BIOS just recently about 2 weeks ago. I just had to change my internet modem yesterday but that should have nothing to do with it.Thanks for any help.

:)

 

Keep getting blue screen on restart & shut down

DRIVER_IRQL_NOT_LESS_OR_EQUAL is likely to be caused by a driver and is usually caused by drivers that have used improper addresses. Stop error codes may be fixed by updating Windows. As a first troubleshooting step, we suggest that you check if there are
updates waiting to be installed on your device. If there are, kindly install these updates and restart your computer. After restarting your computer, see if it still shows the stop error code when restarting or shutting down your computer. Here's how to check
for updates in Windows 10:

• Press the Start button, then type Windows Update, and select it from the search results.
• On the Windows Update page, click Check for updates.

If the issue is not resolved, do not hesitate to post back to us.

 

Random shut down and restart??

Computer: Intel (R) Pentium (R) Dual cpu
E220@2.406hz
2.42 GHZ, 2.00 GB of RAM
Windows xp

Ever since I replaced the fan (with heat sink) the computer has randomly shut down and then restarted, at first during streaming, and now, will shut down and restart anytime. I tried to replace the graphics card to no avail. *Confused *Mad

One suggestion was to replace the RAM.

Any suggestions on how to repair my computer?

 

STOP error after Windows MCE 2005 clean install

OK, found the rest of it.

A problem has been detected and Windows has been shut down to prevent damage to your computer.

If this is the first time you've seen Stop error screen, restart your computer. If this screen appears again, follow these steps:

Check for viruses on your computer. Remove any newly installed hard drives or hard drive controllers. Check your hard drive and make sure it is properly configured and terminated. Run CHKDSK /F to check for hard drive corruption, and then restart your computer.

Technical information:

*** STOP: 0X0000007B (0xF7C7B524, 0XC0000034, 0X00000000, 0X00000000)