Windows 10: I just turned on my laptop and it says "update runaway" then a bluescreen appears showing...

I just turned on my laptop and it says "update runaway" then a bluescreen appears showing the stopcode "System Service Exception" then it keeps restarting by itself, what should I do?

:)

 

Runaway memory usage

CPU usage graph is still nasty:



And the process list still shows AVGSvc at 13%, and explorer at 13%.

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.

Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

Windows bluescreen

My laptop just finished updating over night and I turned it on and waited a while so that everything would load up (which took a bit longer than usually) and then I opened Blender 3d (modeling program) and this bluescreen just appeared, it's not the first time that a bluescreen has appeared after opening Blender 3d, but when it (the bluescreen) has appeared (about 3 times) windows takes care of the problem.

The bluescreen says:

Stop code: DRIVER_IRQL_NOT_LESS_OR_EQUAL

What failed: nvlddmkm.sys

It has stayed at 0% complete for about 40 minutes now (since 5:00 pm).