Windows 10: I keep getting BAD_POOL_CALLER when launching SKSE after resetting bios

So I messed with my bios the other day and my monitors would just stay off after I turned game boost all the way up so what I decided to do was clear my bios but that started causing me to get a blue screen whenever launching Skyrim through SKSE now the error codes are different from time to time I get two different ones one being "BAD_POOL_CALLER" or "KERNEL_MODE_HEAP_CORRUPTION" I don't know what to do at all and I don't know what I could've possibly changed in bios any help would be appreciated thanks!

:)

 

Bad_Pool_Caller


I have read quite a few "Bad_Pool_Caller" posts and none that I've read have been any help. It really is getting frustrating; as many as three times in a day. I've tried safe mode, but couldn't figure anything from that. In fact as I write here I'm expecting a crash. Jeez this really is a backward step. I don't remember windows 3 crashing like this with no explanation as to what is causing the crash. I have a Dell Studio 1747 laptop (six years old now). I installed a 240GB SSD drive a week or so ago. I can't remember if I had these BSOD's with the old drive. I've attached the suggested system file from previous posts. I notice ads to repair this problem, but hesitate to try them; any suggestions on that.

Thanks, Allan

 

bios

Hi all i am new in this forum, i need meanings step by step of each item listed in the bios Phoenix-Award

 

Resetting Bios Password

I am doing some spring cleaning, getting rid of old desktops, laptops, and routers. Regarding the computers, I am wanting to wipe the hard drives with Darik's Boot and Nuke software. When I booted up one old Dell desktop from 2001, I learned that it requires a BIOS password. Why I ever put one on is beyond me. Unfortunately, I have forgotten the password. The rest of this message will be about wanting to know if my understanding for resetting the BIOS password is correct.

Technically, this thread/message isn't about Windows 10 specifically. But it does relate to hardware, and I am hoping that it would apply to a significant number of computers, so I hope this message is okay.

I called Dell, and the technician said that I needed to reset the jumper on motherboard to reset the BIOS password. After opening the case on my old Dell computer and hunting on the internet, this is the what I think I have learned. I will present photograph of a portion of the motherboard.





I have put a red rectangular box around what I think is the jumper for the BIOS. I note that "PASS" is written on the motherboard beside those three pins.

I believe these are steps I need to follow. Please correct me if I am wrong.

1. Turn off and unplug the computer. (It has been off and unplugged for about ten plus years. I just plugged it in today. I am not sure if this information is relevant. Perhaps it helps with regard to the motherboard's battery.)
2. Open the case and locate those "PASS" pins again.
3. Switch the jumper from the current two pins to include the third pin and middle pin. Leave it there for 5 seconds or more. In other words, move the jumper over one pin for a few seconds.
4. Reset the jumper back to its original position with the original pins.
5. Plug in the computer, and attempt to boot it up.
6. Assuming it boots up, open CD tray and put in Darik's Boot and Nuke software and follow the steps.

Is there any information that I am missing? Do I have the correct location for the jumper? Are my steps correct?

Thank you for your help.