Windows 10: I keep getting BSOD everyday

the stop code is: driver power state failure, i keep getting the BSOD twice everytime I turn on my PC. After which, it run completely fineI found this in the event viewer thing:+System-Provider[ Name]Microsoft-Windows-Kernel-Power[ Guid]{331c3b3a-2005-44c2-ac5e-77220c37d6b4}EventID41Version9Level1Task63Opcode0Keywords0x8000400000000002-TimeCreated[ SystemTime]2024-07-29T07:13:12.6658680ZEventRecordID177016Correlation-Execution[ ProcessID]4[ ThreadID]8ChannelSystemComputeradu_eng_qun-Security[ UserID]S-1-5-18+EventDataBugcheckCode159BugcheckParameter10x3BugcheckParameter20xffffd08465b22d50Bugch

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Multiple BSOD's Everyday

Hey,

I have recently purchased a new NVMe SSD, but as the title suggests, ever since I started using this SSD, my laptop has been bluescreening a few times everyday (rarely once), with various different stop codes. Some of these stop codes are:

KERNAL_SECURITY_CHECK_FAILURE

KMODE_EXCEPTION_NOT_HANDLED (What failed: iaStorAC.sys)

IRQL_NOT_LESS_OR_EQUAL

I didn't think this issue would appear so often, so I only started paying attention to these codes recently, thus why I only have a few to list. If anyone could help out a little, that would be much appreciated!

Thank you.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.