Windows 10: I keep getting BSOD's intermittently and can't figure out what the problem is

I keep getting BSOD's and crash sometimes 2 times in one day or weeks. I use it primarily for gaming have removed overclock and disabled XMPI have about 5 minidump files I can analyze and postIRQL_NOT_LESS_OR_EQUAL aAn attempt was made to access a pageable or completely invalid address at aninterrupt request level IRQL that is too high. This is usuallycaused by drivers using improper addresses.If a kernel&nb

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Intermittent black screen problem in Windows 10

Hi Warren,

There are several reasons why you are facing an intermittent black screen issue. One of these is due to outdated or incorrect device drivers. For us to figure out what's causing this, provide more details by answering the listed questions:

• On which scenarios did the black screen issue happen again?
• Have you recently installed any updates?
• Have you made any particular changes to your device prior to this happening?
• Are there any 3rd party programs or software installed on your computer?
• To make sure we have not missed on anything, may we know the list of steps that you have done to resolve the issue?

Your response is greatly appreciated.

 

Intermittent BSOD

I've been getting these intermittent BSOD's and I don't know why. I've been running the same settings that have proved stable through rigorous months of F@H/WCG and stability tests. My memory should be stable, I've tested it with Memtest86+ (the bootable ISO version). My CPU should be stable, I've tested it with 6 hours of OCCT Linpack. My GPU should be stable, it's ran F@H flawlessly for about 2 months now, and it's passed testing with Furmark and the OCCT GPU test.

I've undervolted my processor to 1.30v from 1.325v stock... I have put it back to stock voltage. We'll see how it goes.