Windows 10: I keep running into this error

<Event xmlns="http://schemas.microsoft.com/win/2004/08/events/event">- <System> <Provider Name="Service Control Manager" Guid="{555908d1-a6d7-4695-8e1e-26931d2012f4}" EventSourceName="Service Control Manager" /> <EventID Qualifiers="49152">7009</EventID> <Version>0</Version> <Level>2</Level> <Task>0</Task> <Opcode>0</Opcode> <Keywords>0x8080000000000000</Keywords> <TimeCreated SystemTime="2024-05-12T00:22:51.3833210Z" /> <EventRecordID>7160

:)

 

Error: No work available to process

Hmm. Either it's put out errors and WCG is limiting the work units available, or the project list may not be set to supply other WU when one runs out. (if the problem lies here and not on your end)

On the options to your left, if you go into Results Status, select the computer from Device Name and then look through results see if either they were returned late, errors or any other kind of issue that would stop the servers supplying WU from that perspective.

If there are no errors then it's maybe down to your project list. So selecting Device Manager from the left menu and then clicking on the profile assigned to that computer and make sure that it's assigned to receive WU for other projects if they run out.

At least those steps will rule out problems from the WCG end.

 

Running Optimize literally does nothing; in PS it yields an error

After doing a clean install of Windows 10 20H2 (OS Build 19042.906) and fully updating it, and updating all of the Dell drivers from Dell.com, I tried the following Optimize and Defrag options from How to Optimize and Defragment Drives in Windows 10 (tenforums.com/tutorials/8933-optimize-defrag-drives-windows-10-a.html):

• OPTION ONE: To Optimize Drives in Optimize Drives Tool: Steps 2, 3, and 4,
• OPTION TWO: To Optimize Drives in Command Prompt: Step 2, and
• OPTION THREE: To Optimize Drives in PowerShell: Step 3

The four steps attempted from Options 1 and 2 resulted in no notice action; i.e., it appeared as though nothing happened after executing the commands.

When I ran Step 3 of Option 3, I received the following error message.

What does this mean and now what do I do?

Thanks!

 

when i rebuild bcd,run bcdedit /export c:\bcdbackup,An error occurred

an ERROR IS The storage export operation has failed and the system cannot find the specified FILE because when laptop startup,screen display Not connected or unable to access the required device Error code 0Xc000000e but，i run bcdedit /export d:\bcdbackup,The screen shows that the operation was successful I run these commands step by step 1.bootrec /fixmbr 2.bootrec /fixboot 3.bootsect /nt60 sys 4.bootrec /fixboot 5.bcdedit /export c:\bcdbackup 6.attrib c:\boot\bcd -h -r -s 7.ren c:\boot\bcd bcd.old 8.bootrec /rebuildbcd An error occurred in the fifth step i use diskpart and list volume Disk C is only 260M, Disk H is the system disk, Disk D is a removable disk so What command should I enter in the fifth step