Windows 10: I need help with Diskpart Command Prompt.

Hello,I need help with Diskpart Command Prompt.The sources are incompleteI used it frequently about 3 years ago. That's why I know. I'm sure. But, I can't remember now.What I want to doelete the 240 GB hdd, which is disk 0Split it into two parts, 140 GB as the primary partition and 100 GB as the secondary partitionFormat each partition as NTFSAssign the letter C to the 140 GB partitionAssign the letter D to the 100 GB partitionActivate the C partitionI should only use diskpart for these operationsCan you help me?

:)

 

command prompt will not open in safe mode with command prompt

Would I just follow the same steps within safe mode after hooking up to the other system?

 

command prompt is x:\windows\system32

My computer crashed and I have tried everything I can think of you restart, but the command prompt starts with x: instead of c: I've tried the fixes suggested and listed below:

In Command Prompt, type DISKPART, press Enter.

When it loads type LIST DISK.

Choose the Windows hard drive by typing SEL DISK # with # being the desired disk number from results.

Then type LIST VOL which will provide a list of the various partitions with their assigned drive letters in Recovery mode which may be different than in Windows.

But when I type in DISKPART is says There are no disks to show

Any ideas?

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that