Windows 10: I need to install win 10 on a new hdd

I have the factory key but i have installed a new hdd. I need to format that and install a new windows os

:)

 

Install of Win 10 from old HDD to new SSD

My PC has a WD 1 T HDD as the primary drive with Win 10 installed. There is also an 2nd older WD HDD for data storage purposes if ever needed - unlikely.

I recently bought a new 500 GB SSD drive. I would like to install my WIN 10 on the new SSD using it as the primary drive.

To install on the new SSD, would I unplug the WD 1 T HDD and install the new SSD drive on the MB and then install Win 10 on the SSD.

After the above, I assume I then reconnect The WD 1 T HDD. With the OS on the New SSD, will the apps and programs that are on the WD HDD operate or will I have to reinstall them on the new SSD As well how do I delete Win 10 from the HDD - do I simply delete the files or delete the partitions or just don’t bother. The WD HDD a was not even close to being full and was bought for faster access.

Any suggestions on how to get the new SSD to work properly and windows off the old WD HDD so it does not interfere with the new SSD would be appreciated.

 

A new win install on a HDD messed up my win install on my m.2 SSD




- - - Updated - - -

Yes, I do think that is my problem, but I couldn't find a way to remedy it. Sorry for the screenshot being in Hungarian, if you need I can translate it. And don't mind the 500 MB partition, I tried to do a fix from a similar thread which suggested creating it, but later steps didn't prove successful.

 

Installing a new HDD to replace a HDD of the same size that failed.

I have a Windows 10 OS installed on my C: drive. I had data stored on an HDD designated as D: drive. That second drive failed and was replaced by a new HDD. Both are the same size and type of drives, except different manufactures. The new HDD is not
listed in File Explorer. It is listed in Computer Management under Device Manager as a Disk drive. Disk Management under Storage does not list the new HDD.

I have tested the new HDD with software downloaded from the manufacture and it has passed all tests. At least that software was able to access the new drive and perform low level tests to see if it is operational.

Looking at the events log for this HDD, I find an event warning that says "Device ... was not migrated due to partial or ambiguous match." Opening up the properties indicates drivers have been installed. Reading the volume information results in: "Volume
information for this disk cannot be found"

I suspect that the problem with the volume information is associated with the warning in the event log. I removed the HDD, restarted the PC then shut it down to start the installation process over again. No change in the event log or status of the new
HDD. Can anyone suggest how I can get past that warning?