Windows 10: I shutdown my HP computer during setup sequence and now its in a restart loop

So I got the computer and while I was setting it up I shut it down for some reason and now it restarts over and over.Every time now after it restarted it shows;RecoveryYour PC couldn't start properlyA required device isn't connected or can't be accessed.Error code: 0x0000225You'll need to use recovery tools. If you don't have any installation media like a disc or USB device, contact your PC administrator or PC/Device manufacturer. Press Enter to try againPress F8 for Startup SettingsPlease help me, I want to use my new computer

:)

 

HP Laptop Boot Loop

I am encountering a boot loop problem with my HP laptop. Upon startup, it shows the HP logo and loading dots for about 11 seconds, then goes to a blank screen for approximately a minute before automatically restarting. The power button does not turn off during this cycle.

Troubleshooting Steps Taken:

• Tried hard reset and accessing BIOS/UEFI settings.
  
• Unable to boot into Safe Mode or recovery environment.
  

please see here the recorded video demonstrating the boot loop behavior for reference.

Any advice, troubleshooting steps, or insights into what might be causing this problem would be greatly appreciated.

Thank you in advance for your help and suggestions.

 

FirstLogonCommands with shutdown in the sequence

I'm going to do some more testing on that. Those commands I have after the shutdown take a long time to run, and it didn't restart until all of them had completed. But if the system schedules them as runonce commands, then that suggest a way to handle (for example) if one of the commands was to install a software package that required a restart before the next command could be run. It would be fine with the restart, but I would just have to find a way of preventing the next synchronous command until the restart completed. I'll post here with more findings. - - - Updated - - - OK, I don't know why it appeared, earlier, that shutdown "waited" until the rest of commands were complete, but my current testing indicates that shutdown happens in sequence, and the FirstLogonCommands resume after that. Now what I need to figure out is whether it does so synchronously. From what I understand, shutdown.exe doesn't directly drive the shutdown process, but just schedules it and then returns. If returning is the "end" of the task, so that the next task is started, then it could be interrupted by the shutdown. More info to come... - - - Updated - - - It turns out the shutdown does interfere with the next command. It appears the way to shutdown synchronously during a FirstLogonCommands sequence is to create a script something like: Code:

The "Shutting down" never displays but the /K keeps cmd.exe from returning so that the next synchronous command doesn't start until the shutdown.

 

Windows 10 restart loop

Hi,

To understand the issue better, I would like to ask some questions:

• What is the make and model of your computer?
• Do you get any error message?

I suggest you to follow the steps provided by Andre Da Costa from the link provided below and check if it helps.

Redirecting

Hope this helps. Keep us posted on the status for further assistance.