Windows 10: I switched my motherboard and now the DRAM debug light is on, what is the problem.

I recently switched out my motherboard and now the dram debug light is on. I switched the RAM out and still nothing is happening, there is no display

:)

 

PC Not Booting DRAM Flashing on Motherboard

A couple of days ago I performed a scan and clean on my computer with the software I had downloaded. I had used it multiple times with no issues just to make sure all of my drivers were updated and there were no useless files on my computer to keep more free storage.

The other night after performing a scan my mouse quit working. Everything else was fine. I turned my computer off and came to it the next day and logged on and it booted up fine, but the mouse still wasn't working. I restarted the computer and it wouldn't boot into Windows 10. It just stays on the Aorus screen. It won't allow me to hit the F12 button for the boot menu. I hit it, but nothing happens.

I checked my motherboard and the VGA square was lit up red. I reset my graphics card and tried it again. The same thing happened, but then the DRAM square lit up red on the motherboard.

I took both of my RAMs out and reset them. Now the motherboard has the DRAM lit up, but every 10 seconds the CPU square lights up red then it switches back to the DRAM lighting up.

Any help would be greatly appreciated.

 

Pc Freezes and having no display after restart.

I tried to disconnect my second monitor but i still had no display. i tried to switch my ram slots but again no display. I noticed that on my motherboard there are two led lights turning on and off again and again. those led lights are Dram and cpu debug. if i am not mistaken. thanks for your patience !!

 

Ethernet is showing as Kernel Debug Network Adapater

Hi,



Thank you for writing to Microsoft Community Forums.



I understand that you see Kernel Debug Network Adapter in Device Manager. This can happen if debugging is turner on. I would suggest you to turn off debugging by following the steps mentioned below:

1. Type command prompt in the search bar on the
   Taskbar.
   
2. Right click on the command prompt icon and select
   Run as administrator.
   
3. Paste the following commands and hit Enter:
   
   bcdedit /debug off
   

If you still see the Network Adapter, you can disable it from Device Manager without problems. Refer the steps mentioned below:

1. Press Windows Logo key + X, to open
   Device Manager.
   
2. Expand Network adapters.
   
3. Now, right click on the Kernel Debug adapter and select
   Disable device.
   

Let us know how it goes.



Regards,

Nikhar Khare

Microsoft Community - Moderator