Windows 10: I tried resetting my pc and I need help

I tried to reset my pc yesterday and everything was going fine after it restarted it didn’t connect to the monitor even though the pc was on?

It was like that for about 8 hours then I just turned it off by the button, after doing that I tried resetting the pc again and that made no difference the exact same thing happened. I eventually got it back again and this time I tried to play a game but nearly everything was uninstalled which was weird. I then tried to just reset the pc again and now I literally can’t get it to connect to the monitor? My keyboard keeps flickering on and off too.

Any fix to this? I don’t understand what’s going on with it and why it couldn’t just reset to factory settings rather than cause all this fuss.

Any reason as to why it won’t connect to the monitor but the pc itself is on?

Why it couldn’t just factory reset?

Any help/fixes would be extremely appreciated!

submitted by /u/BADMAN5568
[link] [comments]

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

1070 Overheat Crash x(

Yes try it again... lol... we were waiting for that!

You have steps listed....try to find a another pc to try...try to reset the bios and see if that for some reason would help. But yes, try putting it back in. If not, id say rma time.

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks