Windows 10: I tried to restart my computer and it ended up breaking and I’m not sure what to do.

Completely reset my computer and it’s not working. I have tried the cloud I have tried the local reinstalling and everything I do to reset my computer to factory is not working and I’m not sure what I’m supposed to do. I have been fighting with my computer to get it to start working again for about Eight hours now and it’s not wanting to work. I have no idea what to do. It’s an Alienware Laptop and it’s worked just fine up until this point so I thought factory resetting it would help but I don’t know what it did.

:)

 

M-Audio M-Track 2x2 Not Recognized by my computer.

Hi,



Thank you for writing to Microsoft Community Forums.



We appreciate the research and troubleshooting you have done, this issue could be from the software end or from the hardware itself.



Please try few of the troubleshooting below to further eliminate the root cause of the issue.

1. Try to connect the device with a different USB and check if that helps.
   
2. Connect the M-track to different computer and check if you still face the issue there, if the issue persists, it could be caused by hardware.
   

Method 1:

1. Press Windows + R key on your keyboard together, and type
   control printers.
   
2. You will see list of all the devices and printers connected to your computer.
   
3. Click on Add a device and follow the onscreen instruction and add your device.
   

Method 2:

1. Uninstall
   all the M-Track drivers from device manager.
   
2. Reboot the computer and check.
   

Method 3:



I suggest you login to the manufacturer site,
download the drivers for your registered device and
install it.



If you still face the issue, I suggest you to get in touch with the
manufacturer and get the hardware checked once.



Hope it helps.

Amit Sunar

Microsoft Community – Moderator

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 Pro and Ergnomic Break Reminder

Hi,



Apologies for the late reply.



Do you remember installing any break reminder software?



It looks like it is a pop up from a break reminder software.



I suggest you to look for this in Programs in features and uninstall it if do not use it.



Try the following steps:

• 
  Press Windows + R keys to open Run Command
  
• 
  Type Appwiz.cpl and hit enter
  
• 
  Search for the programs and un-install it.
  

Regards,