Windows 10: I turn on my pc goes trough screen that says press f2 to go to bios then it says undoing...

Please answer my question

:)

 

Pc stuck on press del or f2 to enter bios

Hi jeremiah,

I am Dave, I will help you with this.

That indicates there is either a problem with your BIOS.

Press F2 to enter BIOS

Find the option to restore BIOS defaults and apply that.

Save those settings and exit BIOS

Then check if your PC will boot into Windows normally

 

PC screen goes blank when attempting to enter UEFI/BIOS

I am following the steps below to get into BIOS, but when I click restart at the end, my pc restarts, but never enters BIOS. It shows the pc make (Asus) and then goes to a blank screen.

I try hitting f2 or delete in this blank screen after a while, bit this resolves nothing.

Is there something else I should be doing or something I should do once the screen is blank?

Navigate to settings. ...

Select Update & security.

Select Recovery from the left menu.

Click Restart Now under Advanced startup. ...

Click Troubleshoot.

Click Advanced options.

Select UEFI Firmware Settings.

Click Restart.

 

My pc will only turn onto the bios settings

If your PC is only turning on to the BIOS settings and you are unable to boot into Windows, it may be due to a hardware issue or a problem with the operating system. Here are some steps you can take to try and fix the issue:

1. Check the boot order in BIOS:
   

• Enter the BIOS settings by pressing the appropriate key (usually F2 or Del) during startup.
  
• Look for the "Boot" or "Boot Order" section and ensure that the hard drive or SSD that contains the operating system is set as the first boot device.
  
• Save any changes and exit the BIOS.
  

1. Check for loose connections:
   

• Turn off your PC and unplug it from the power source.
  
• Open up the PC case and check all connections between components (such as the hard drive or SSD and the motherboard) to ensure they are properly seated.
  
• Close the PC case, plug it back in, and turn it on to see if the issue is resolved.
  

1. Perform a startup repair:
   

• Use the Windows installation media (such as a USB drive or DVD) to boot into the advanced options screen.
  
• Select "Startup Repair" and follow the prompts to attempt to repair any issues with the Windows operating system.
  

1. Reinstall Windows:
   

• Use the Windows installation media to perform a fresh install of the operating system.
  
• Note that this will erase all data on the hard drive or SSD, so make sure to backup any important files beforehand.
  

If none of these steps solve the issue and you continue to see the "no bootable device detected" message, it may be due to a hardware failure such as a faulty hard drive or SSD. In that case, you may need to replace the failing component or seek professional assistance.