Windows 10: I update my windows 11 PC and now it’s stuck on dram light

I just finished using my PC, when I about to shutdown, I noticed a new windows update, I clicked on the “update and shutdown” option. After it reached 26%, the computer restarted and stuck on rebooting over and over. My rams have lights and when it tried rebooting, the rams’s light doesn’s light up and the dram light on my mainboard is glowing red.I force shutdown it by holding the shutdown button. And then I turn it on. It still have the same problem. I tried removing one of my ram stick I had 2 16gb ddr5 ram and rebooting it but it still didnt change. I recently change my PSU to a higher w

:)

 

Pc will crash randomly to black screen with yellow dram light on

Occasionally my pc will crash to black screen and reboot after a few seconds. The dram light is a solid yellow. I check the qvl list and my ram isn’t on it but otherwise it runs fine and I did memtest86 and it ran fine on all 4 passes with no errors. Could it be my psu or something else? Try to get new ram? If there are any tests that I could try to run to figure this out it would be great. My bios and drivers are all up to date and I tried clearing the cmos too.

 

DRAM Change and Windows 11 Goes Wild

Today I installed new DDR4 3200Hz. RAM and a benchmarker suggested I turn the BIOS DRAM to XMP II and 3200Hz. The computer crashed with Pool corruption infib, Kmode area exception not handled, System thread exception not needed, IRQL not less or equal, PFN list corrupt by pointer, memory management. Most benchmarkers crash.

 

I switched my motherboard and now the DRAM debug light is on, what is the problem.

It got rid of the dram debug light but now the cpu debug light is on