Windows 10: i want to format my pc

hello guys my pc is too laggy and i have to format it 2 years.I want to fully format it but i dont know very good.I have windows 10 and as i see in google sites i just go to reset pc and choose the options that you want but after this what i will need to install and set the windows?i think the windows will be downloaded automatically but i dont know what it will ask me......I want help a bit if you can to help me i would be thankfull

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Cannot Format HD


Need to initialize it as GPT disk type with HD > 2TB:
From Admin command prompt:

• diskpart
• list disk =====> Take a note of disk # for the 4TB HD
• select disk # ====> From step 2
• clean
• exit

Open Disk Management and initialize the disk as GPT, create simple then format.

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??