Windows 10: I was doing windows reset and when it complete 64% it restarted many times and nothing happened

I was doing windows reset and when it complete 64% it restarted many times and nothing happened

:)

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.

Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.

I want to follow the suggestion. But It is that before making a decision or action I usually analyze it or ask a little more, as long as it is something new for me
:/

Before Reset the Windows Update should I take into account the results of the Windows Update Troubleshooter ? The WUT of Windows itself does not correct the problem it finds. But the other WUT shows me (after the second attempt) as "corrected" and "completed".



What I do not understand is why the WUT tells me that one of the steps is to remove the updates and re-download them (red rectangle). But when I give in "apply this correction" does not eleminate the update(Should?)




Already in the final step in the report it tells me: that it is "corrected" in the first line. In the second it indicates "completed" and the text there says that one of the steps is to remove and re-download the update (is it supposed that WUT already did it or should I do it?)
And what is that appears in the green box. Should I download it, remove it?




Sorry if maybe I have not explained well before. I think it would be much easier if the OS language were in English because translating the texts of the images is a lot.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".