Windows 10: I was running an update and lost power. My screen is now stuck on you're 100 percent there....

I was running an update and lost power. My screen is now stuck on you're 100 percent there. Please keep your computer on. It has not changed for 30 minutes. Please help.

:)

 

Build 15007 is stuck at 100 percent??

Download is stuck at 100 percent. How to get it to start install???

 

windows update stuck at installation screen and cannot get to desktop

Hi Sue,

To understand the issue better, I would like to ask some questions:

• Is the computer stuck in the Installing updates screen?
• For how long is the computer stuck in the screen?
• When was the computer last updated?
• Is the screen showing any percentage of installation?

Sometimes the installation might take a long time to install if the update is of large size. So, I suggest you to wait for sometime and check if the system boots to the desktop. If it is taking a longer time, then perform a Power Drain by following the steps
provided below:

• Shut down the Computer.
• Remove all power source (including battery if it is a laptop).
• Press and hold the power button for 15-20 seconds.
• Connect the power source and start the computer.
• After the computer boots to the desktop, suggest you to install all the pending updates.

Hope this helps. Keep us posted on the status for further assistance.

Thank you.

 

CPU Stuck at 100 Percent Load Until Power Plan is Changed

My CPU automatically goes to 100 percent load at startup. This issue is resolved for a short time if I change my power plan to a different plan. After a few days my CPU goes back to 100 percent on the new power plan, causing me to switch to a new plan I
haven't used before.

This issue is causing me to duplicate a plan I haven't used before multiple times, so that I can switch to them as the previous plans I use get "infected" by the 100% CPU issue.

Basically this is what happens:

Use plan 1 until CPU hits 100% >>> Switch to plan 2.

Use Plan 2 >>> Duplicate plan 3 for future use since I haven't used it yet.

Plan 2 stuck at 100% CPU >>> Switch to plan 3 duplicate.

Use Plan 3 duplicate >>> Duplicate plan 3 again, to switch to later.

I have tried to go to the advanced power options for each of the plans to "Restore plan defaults" but that button is greyed out, even if I select the link "Change settings that are currently unavailable".

If anyone can help me it would be greatly appreciated.