Windows 10: IGCCTray has stopped working

I have IntelR HD Graphics 520 as my display driver adapter. The driver is now updated to 9/5/2020 and yet it was installed earlier to 2021 year. I have installed the IntelR Graphics Command Center. Whenever I try to open that, it loads couple of seconds then a message appears that says "IGCCTray has stopped working". When the driver was installed to 2021 year, it gave the same error. I don't know what could cause this error. I tried upgrading/downgrading display driver, reinstalling IntelR Graphics Command Center but without succees.

:)

 

Windows 10 infinite restart black screen


The tutorials provided are just a list of troubleshooting steps. Use only the steps which apply to you.

Since none of the troubleshooting steps here worked, I'd suggest you do a Clean install.

John

 

Email, contacts, store etc... stops to work

Hi,

I suggest you to follow the below steps and check if the issue is resolved.

• Press Windows key + X key and select
  Command Prompt (Admin)
• Type the following commands in the given order and press Enter
  key after each command.

1. net stop wuauserv

2. rename c:\windows\SoftwareDistribution softwaredistribution.old

3. net start wuauserv

• Restart the system and check if the issue is resolved.

After performing the above steps, I suggest you to try installing all the updates available for the system and check if it helps.

Hope the information helps. Kindly write back to us for further assistance on Windows. We will be happy to assist you.



Thank you.

 

Show windows side by side has stopped working in W10?

Hi Mary,

For better assistance, verify the following information:

• Were you able to check the response of Vinodh.V posted last August 5, 2015?
• Did you perform the suggested troubleshooting steps provided on this thread?

If the recommended solutions did not work for you, we suggest creating a new thread since some troubleshooting steps may no longer be applicable to your issue.

We're looking forward to your reply.