Windows 10: Im having an error after hard resetting

I just factory reset my pc anf i am constantly crashing then getting this error in event viewer.The computer has rebooted from a bugcheck. The bugcheck was: 0x0000007e 0xffffffffc0000005, 0xfffff803a0534afa, 0xfffff5834d50e008, 0xfffff5834d50d820. A dump was saved in: C:\Windows\MEMORY.DMP. Report Id: 71e94bee-08da-48b2-a50f-7d12fad4ac56.

:)

 

Contest! Win Hard Reset!

Bump

No one wants Hard Reset? I'm open to other suggestions for contest ideas.

maybe i got this in the wrong section... could a mod move it to the FS/FT/WTB/Giveaway section?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Im having a Repair C drive Errors.

Try This

Follow these steps to repair corrupt hard disk without formatting, and get back the data.

1. Step 1: Run Antivirus Scan. Connect the hard drive to a Windows PC and use a reliable antivirus/malware tool to scan the drive or the system. ...
2. Step 2: Run CHKDSK Scan. ...
3. Step 3: Run SFC Scan. ...
4. Step 4: Use a Data Recovery Tool.