Windows 10: Immediately enters Powersave Mode after Boot [Windows 10]

After attempting to perform a "fresh start" Windows 10 update, the computer boots past the Dell logo, the Windows logo appears, spins, and starts up , then immediately it enters powersave mode, and the monitor turns off. The desktop will not wake up. When I attempt to reboot to Safe mode or access the OS on disk, I can only access the install OS environment with the command line, reset, and advance options. The computer previously would not accept any feature updates beyond 1909, so after trying many support articles to accept 20H2, I attempted the f

:)

 

Cannot Enter Safe Mode / Computer boots normally

I'm running Win 10 Pro 1903.

Here are the steps I have taken to get into safe mode: Start button, settings, update and security, recovery, advanced startup, troubleshoot, advanced options, startup settings, restart. The computer boots normally, not in safe mode. Any suggestions would be most helpful. Thanks in advance for your help and interest. .

 

Upgrading cpu and mother without reinstalling windows 10

in most cases you can do exactly what you are trying to do by taking the os drive and plugging it into the new system and booting in safe mode. once in safe mode open a command prompt as administrator and type "set devmgr_show_nonpresent_devices=1" hit enter. then type "start devmgmt.msc" hit enter again and device manager should open up. after that click the "view" tab and select "show hidden devices". then you just expand each list and unistall all the drivers that are slightly transparent. once you are all done go ahead and reboot the system and install all the new drivers. in most cases this is enough and does not need anything more done.

edit: just boot the os into safe mode the first time and let it install drivers then reboot and fallow the steps i listed above. back with windows vista and earlier windows versions this would be problematic but sense 7 ive found that swapping boards from different manufacturers and even amd to intel has become mostly doable. ive done it a handfull of times.

 

Sabertooth 990fx won't boot to windows logo, it shuts down

to boot and enter bios and load windows, any todays PSU (with the correct plugs) will work, AFAIK

to enter BIOS only low wattage is used.
Then, during boot, the HDD and a bit later the videocard card start to demand juice, then the other devices and periphericals... so the total demand during boot up is incrementing step by step, that's why a failure halfway could indicate a PSU problem....