Windows 10: in need of help, updated pc bios and windows drivers and now it doesn’t work

I recently updated my bios to enable tpm so that I could update my windows to windows 11. Shortly after completing this I wanted to play a game, but was required to enable secure boot in my bios before I could launch the game. Once I enabled it my pc went to restart and the screen stayed black. After hard powering it off and back on I lost all power to external devices such as keyboard, mouse and no signal on my monitor. I think I may of used the wrong driver when updating. However Iv tried taking out and testing the gpu, rams, taking out cmos battery. And even tried Q flash/ usb recovery and

:)

 

Windows doesn`t start. Authomatic repair doesn`t work.

Thanks again!!

I`m sorry I had not noticed that the text on the picture was in spanish. It says that windows has replaced some damaged clusters in "name" file and "directory". Then, at the end "an unspecified error occurred (75736e6a726e6c2e 4f6)".

I`ll do it and I`ll be updating this thread when I have the report.

- - - Updated - - -

I ran SeaTools. These are the results:




Does it mean my HDD is useless?

 

Scanner doesn´t work anymore after last Windows 10 update

As many people on the internet already are discussing, their scanner doesn´t work anymore after the last Windows update. But there seem to be no solution.

My Scanner starts making noises, as usual, and then i get error messages: "Communication with the scanner is not possible"
or this




Is there a workaround for that?

 

Scanner doesn´t work anymore after last Windows 10 update

I dunno.

Re-install the TWAIN drivers? (They are not included in Windows.)

You might get a better answer if you gave the make and model of the scanner.