Windows 10: In network usage I found something that name is vs graphics desktop engine host exe which...

In network usage I found something that name is vs graphics desktop engine host exe which is highly using my internet I'm unable to Stop it

:)

 

svchost.exe / service host : local system ( network restricted ) high usage memory and CPU

When you open Task Manager a little bit, you’ll see that svchost.exe service host: local system (network restricted) is causing the problem of high CPU usage. To improve your Windows performance, and get rid of the high CPU usage, you
have to disable Superfetch service. Superfetch used to pre-load data from hard disk into RAM memory. So let's follow this steps.

Fix svchost.exe service host: local system (network restricted)

 

Hotspot not working error HOSTED NETWORK SUPPORT:NO

Hi Phani,

Thank you for posting in Microsoft Community.

I understand your concern and frustration you have been through. I will be glad to assist you.

I appreciate the troubleshooting steps you have tried to resolve the issue.

• What is the make and model of your computer?

I suggest you to refer the link below suggested by JayCap on November 19, 2015
and perform the troubleshooting steps suggested and check if that helps.

Redirecting

Hope this information is helpful. Please do let us know if you need further assistance, we’ll be glad to assist you.

Thanks

 

Windows Shell Experience Host using 35 to 55% of CPU usage on Windows 10

Hi Don,

Thank you for posting in Microsoft Community, we appreciate your interest in Windows 10.

I understand your concern about CPU utilization by Windows Shell Experience Host, we will help you with this issue.

I suggest you to try few of the below troubleshooting steps and check if it helps.

Step 1: Try to end the process from Task Manager and check.

• 
  Press Ctrl+Alt+Del together to open
  Task Manager.
  
• 
  Go to Processes tab, right-click on the Windows Shell Experience Host process and click
  End Process.
  

Step 2: Boot the computer in to Safe mode with networking and if the CPU usage is same.

Refer: Start your PC in safe mode in Windows 10


Step 3: I suggest you to install all the pending updates after upgrade to Windows 10.

• Connect to the internet.
• Press Windows key and type
  updates.
• Click on Check for updates.
• Under Windows Updates, click on
  Check for updates.
• Try to install the updates being shown.

Also, visit the computer manufacturer’s website and install the drivers being found and check if it helps.

Hope it helps. Reply to the post with an updated status of this issue for further assistance.