Windows 10: installing a new printer scanner and finding old scanned documents

I'm installing a new printer scanner and want to make sure my old scanned documents are still where they always were in windows 10 on my laptop, please.

:)

 

Old Scanned Document Still Appearing in Preview

I have Canon MG2520 printer/scanner. I am trying to scan a new document but keep getting the old document in my preview. The old document was scanned & saved. First, I got a scanner not attached but that was resolved through rebooting. How to I remove
the old document from my preview? Thank you for your assistance.

 

Windows 10 recognizes my printer+scanner only as a printer.

Hello,

Another method you may try is to uninstall and reinstall the printer. The following are the steps:



Remove your printer

• Select the Start button, then select Settings > Devices > Printers and Scanners.
• Under Printers & scanners, find the printer, select it, and then select Remove device.

Install or add a local printer

• Select the Start button, then select Settings > Devices > Printers and Scanners.
• Under Printers & Scanners, see if your printer is installed.
• If you don’t see your device, select Add a printer or scanner. Wait for it to find available printers, choose the one you want, and then select Add device.

On the other hand, we suggest also that you reach out the manufacturer of your printer/scanner for the driver availability or work around.



Regards.

 

Can't "Scan To" from printer. Please help!

The scenenario is the following:

We have multiple subnets in our network. One of them is the security one which is 10.224.2.xxx

Computer A is connected directly into it. Ethernet cable comes out of the wall and goes into her Intel NIC.

Computer B is also connected directly into it. However, ethernet cable comes out of the wall, goes into a dock and then through the USB cable, gets internet.

Computer C is connected to our wireless security network which is 10.224.4.xxx
This computer is allowed on the firewall to talk to 10.224.2.xxx

All three computer have Webroot SecureAnywhere installed. The printer is an EPSON Workforce WF-4640. IP is 10.224.2.122 / 255.255.254.0 / 10.224.2.1 gateway / no iPV6 / 192.168.50.18 & .19 are DNS's. Printer has static IP.

I proceeded to install the drivers on all three computers. Here is where the problem comes.

Computer A installs just fine. Finds the printer on the subnet and completes installation. I can print and scan FROM the computer. I can also scan FROM the printer. When I go to "Document Capture Pro", I can see scan to: COMPUTER A on the list.

Computer B also installs just fine. Finds the printer and completes the installation. I can print and scan FROM the computer, but I cannot scan FROM the printer. It just wont list COMPUTER B at all!. I tried plugging the ethernet cable directly into the laptop, but still, the printer will not show computer B in the scan to list.

Computer C the same story, but worse. I cannot finish the installation properly because it will not find the printer. It is obviously on a different subnet, but it will not let me type in the address so I just cancel the printer finder part. I manually go to control panel and adjust the IP parameters. Same thing, I can print and scan from the computer but cannot scan FROM the printer. It will not list Computer C in the list.

I have tripled checked the EPSON Scan software on each PC. Each has the IP parameters set properly. I have spent days installing and reinstalling drivers, but no luck. Printer has updated firmware. I tried disabling Windows firewall, nothing.
At first I wanted to think it was Webroot, since there is a review on Amazon from a guy that had the same problem, but using Norton. However, how come Computer A works just fine?
When I though it was the dock, I quickly found out it was not as explained in Computer B when I plugged it directly.

At this point, Im running out of ideas. Im not even sure where else to go.