Windows 10: Instructions on how to create a Windows disk image on a USB flash drive

How to create a Windows disk image on a USB flash drive using Windows Backup and Restore ____________________________________________________________________________________________________Make sure the USB is formatted to NTFS. Open the USB drive in This PC and create a new folder using any name. Right click on the folder and select Properties. Click Sharing and share this folder. Click permissions and click all boxes and go back. Close these windows. Note Network path. Open windows Backup and Restore. Click Change Settings. Click on the Network path for backup destination you might

:)

 

How to create Windows 10 system image on a usb flash drive

Thanks Maria:

I made a system image on a USB flash drive using the tools available in Windows 10. I want to make this image bootable so that I can reinstall it on my computer from the same USB flash drive. Can I do this using the method you have suggested?

If not, can you or anyone else tell me how to do this?

Thanks again,

Regis

 

Unable to use System restore from a windows 10 image on Windows 7 with error: "windows cannot find a system image-the usb drive is not visible"

Hi Otley,

Thanks for replying to us with the status of your issue.

As you mentioned, when you connect the USB flash drive in to the system then the System image backup is not present. It might occur if the System image files is not created properly or may be it got corrupted.

As an initial steps I suggest you to check for the memory space in the USB flash driver.

If the Memory is occupied in the USB flash drive the I suggest you to try running check disk on USB flash drive and check if it helps.

Follow the below steps to perform Check Disk.

• 
  Press Windows + X on your keyboard.
  
• 
  Select Command Prompt (Admin).
  
• 
  Type the below commands.
  
  Chkdsk [drive letter]: /f /r
  

Reply to us with the status of your issue, we will be happy to assist you.

 

Installing windows off of a USB stick

Step By Step from vista:
From admin cmd prompt

1. diskpart
1a. list disk
2. select disk 1 (replace 1 with your usb drive)
3. clean
4. create partition primary
5. select partition 1 (replace 1 with your usb drive)
6. active
7. format fs=fat32
8. assign
9. exit

Copy Windows Vista's DVD ROM content to the Flash Drive

xcopy d:\*.* /s/e/f e:\ (d being your vista cd and e being your usb stick)

And that's it, boot off your usb disk