Windows 10: Is a 39gb System & Reserve file normal?

I use sleep a little, and it says it has 8gb in hibernation, 18 in system files, 7 gb in system restore, and the rest is in virtual memory this normal?

The system restore section is a little much in my opinion, probably since I use one drive for everything.

submitted by /u/joesleftsock
[link] [comments]

:)

 

System Reserved Memory issue

Hi Rowan,

The reduction in available system memory depends on the configuration of the following:

• The devices that are installed in the computer and the memory that is reserved by those devices
• The ability of the motherboard to handle memory
• The system BIOS version and settings
• The version of Windows 10 that is installed
• Other system settings

As an initial troubleshooting step, I suggest that you check your system for memory problems.

Here's how:

• Type mdsched.exe in the search bar and select the best match.
• When prompted by the User Account Control, enter an admin user name and password, and click
  Yes.
• Follow the on-screen instructions to run it.

Let us know how it goes.

 

Recovery Partition vs System Reserved Partition

Thanks for all the info guys.

Both original & target SSD's are listed as MBR as opposed to UEFI. I may have created a partition unknowingly in getting the original/new unformatted drive recognized, but I don't recall taking any steps that Windows did not step me through.

Not that an upgrade to WIN 10 Pro is contemplated, but I suspect that having no System Reserved partition will not allow that to happen, after seeing how the original WIN 10 upgrade created a problem for some WIN 7 users that had a smaller 100mb vs 500mb System Reserved partition.

 

File Explorer


What I saw from the Disk Management, You did not do a clean install, you probably did an in place upgrade. The 100MB System Reserved is normally used in Window 7. For a fresh install the Disk partition scheme should be as follows:

1. 500 MB System Reserved partition
2. C- Drive.

Since you did not have to many apps installed, I would re-install Windows 10 as suggested above. It is better to have your Windows installed on the first sata port (Disk 0) so I suggest to open the case and connect the cable from disk 0 to disk 2 where you have C: drive. Disconnect the other cables for now and do the steps below:

1. Boot up with Windows installation media
2. On the first screen. Press SHIFT + F10 and type
   diskpart
   select disk 0
   clean
   exit
   exit
3. Continue with Installation, select the unallocated partition then click Next (Do not create partition/format. Let Windows create the needed partitions.
4. Once done, reconnect the other cables for drive D and E.
5. Reboot, your Disk 0 should contain 500MB system reserved and C drive.