Windows 10: Is CHKDSK breaking things again?

I seem to have a bit of a mystery on my hands. Last week I ran CHKDSK /r to check the drive after a couple of power outages. Other than cleaning up security descriptors, everything checked out. However, the Meet Now icon had disappeared from the notification area. The option to have it appear on the task bar was there, but it was gone from the options for turning system icons on or off. I tried running a system file scan, but no corruption was found. A system restore brought the icon back, but due to my antivirus interfering I don't think the restoration was complete and I went ahead and jus

:)

 

Windows 10 Pro and Ergnomic Break Reminder

Hi,



Apologies for the late reply.



Do you remember installing any break reminder software?



It looks like it is a pop up from a break reminder software.



I suggest you to look for this in Programs in features and uninstall it if do not use it.



Try the following steps:

• 
  Press Windows + R keys to open Run Command
  
• 
  Type Appwiz.cpl and hit enter
  
• 
  Search for the programs and un-install it.
  

Regards,

 

chkdsk c: /F

It might be an error on the drive. We suggests that you follow the troubleshooting steps below:

• Run Disk Cleanup utility to clear your junk files.
• Open an elevated CMD type sfc /scannow and hit Enter to run the System File Checker.
  
• Once the scan is completed, restart your computer. Remember to exit ChkDsk
  during boot.
• Next, again open CMD as admin type
  Dism /Online /Cleanup-Image /RestoreHealth and hit Enter to repair the Windows image.
• Now see if ChkDsk able to complete the scan.

Note: Before doing the steps, make sure you save a back up of your files.

Let us know how it goes.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".