Windows 10: Is something wrong with my hard drive? WMI Activity error logs

Hello i was scrolling through event viewer and found WMI activity i went to it and i would open the logs which are very confusing and strange and i am worried something may be wrong but i dont know these are the logs im getting Id = {00000000-0000-0000-0000-000000000000}; ClientMachine = DESKTOP-B1MVRKB; User = DESKTOP-B1MVRKB\isaia; ClientProcessId = 4236; Component = Unknown; Operation = Start IWbemServices::ExecQuery - root\cimv2 : ASSOCIATORS OF {Win32_DiskDrive.DeviceID=

:)

 

WMI error...

I just installed Vista 64 and I've been having problems (go figure). So at the moment I'm running everything stock and stable. I was searching through the event viewer and found one reoccuring error, a WMI error. Here is the SS:





Any info on how I can correct this or if anyone else has run into this problem, please help me if you can. Thanks!

 

Overclock your hard drive!!!

Heres a much easier hack that I realized quite a few years ago that really does work!

REQUIREMENTS:

• Hard drive with molex power connection.
• PSU with more than 1 strand that has molex plugs on it.
• Wire strippers, soldering iron if you're fancy, electrical tape if you're not.

STEPS:

• Take the strand of connectors from your PSU, and decide which one will be the donator for this overclocking adventure.
• Cut the yellow and orange cables, then twist them together.
• Find the power connector you've chosen as the overclocking connector, and release the orange cable from the connector. Now use your preferred method to bind them together, then place it back together.
• Plug in a drive and feel the speed!

Congratulations! You've just overclocked your hard drive!

 

WMI-Activity Error

Hiya, I was having trouble with WMI Provider Host, I googled it and did actually manage to find a thread on here linked below:

Redirecting

That thread's locked now so I wondered if anyone could help me out, my errors list is swarmed but the ClientProcessID in the error isn't anywhere in my Services, and unlike some of the earlier errors I can find, there's no Information file that identifies
where the file is, can anyone help out?